RESOURCE CENTER  
Coming soon...
Creators of the world famous Cheetah Pad surface polishing system!
(800) 280.0333

For use on Concrete, Terrazzo, Travertine & Limestone

Nano Guard is formulated to provide the ultimate in concrete protection by using both dual-action technology and hybrid polymers.  

Nano Guard is environmentally friendly, VOC-compliant and provides increased stain suspension and resistance against most contaminants found in kitchens, retail food stores, restaurants, malls, garages, warehouses, distribution centers, etc.

Designed for use on previously sealed surfaces, as well as surfaces that have been previously stained or dyed and sealed.

Price: $86.50

    Quantity:

    DIRECTIONS: A small test application is always recommended.  The test patch must be done using the same applicator, equipment, surface preparation, application technique and at the same temperatures, relative humidity, airflow conditions, etc., that will exist at the time of the full scale application.  The surface must be thoroughly clean, dry and free of anything that will prevent Nano Guard from bonding properly with the concrete.

    Polished concrete: This product may be applied over concrete that has been previously treated with a densifier/hardener.  Best results are obtained if the surface is burnished two hours after application.  Nano Guard can be diluted with water.  3 Parts water 1 Part Nano Guard.  Dry burnish with 11,000 Monkey Pad after every application

    Application method: Application equipment must be clean, dry and free of any previously used materials.  After initially spraying the product on to the surface, uniformly spread it with a micro-fiber flat mop applicator.  The micro-fiber pad should be pre-wetted with Nano Guard prior to use and the product must not be allowed to dry before spreading is complete.  Optimum performance is achieved with 2-4 uniform coats.  The second coat should be applied at a 90 degree angle to the first coat, only after the first coat is thoroughly dry - and burnished with a dry 11,000 Monkey Pad.  Dry time between coats can range between 30 - 60 minutes, depending on temperatures and conditions. 

    NOTE: Keep surface dry for a minimum of 48 hours after application; full stain blocking ability will not be effective until 72 hours after final application.

    Cleanup: If Nano Guard is still wet, equipment can be cleaned with soap and water.  Once dried, the material can be removed with a solvent such as xylene or toluene or lacquer thinner or ISS Coating Stripper.

    APPEARANCE: Milky White

    SPECIFIC GRAVITY: 1.125

    ODOR:  Characteristic

    pH (Cone): 6-8

    FLASH POINT: N/A (Water Based Liquid)

    PACKAGING: 4 x 1 GALLON CASES

    SAFE STORAGE & HANDLING:  KEEP FROM FREEZING.

    Do not use Nano Guard on fresh concrete.  Do not use as a stand-alone product.  Nano Guard is formulated to provide a reasonable amount of time for cleanup and removal of spills.

    DO NOT MIX WITH ANY OTHER PRODUCTS.

    Direct contact may result in mild irritation.  Inhalation may cause irritation of the respiratory tract.