RESOURCE CENTER  
Coming soon...
Creators of the world famous Cheetah Pad surface polishing system!
(800) 280.0333

RTU Hardener For Concrete, Travertine, Limestone & Terrazzo

Lithium Silicate sealer, hardener and densifier for concrete, cement based terrazzo, travertine and limestone surfaces.

Penetrating product reacts with each surface to produce insoluble calcium silicate hydrate within the pores of the concrete, terrazzo, travertine and limestone.  

Surfaces treated with this product will be more resistant to damage from water, surface abrasion and chemical attack.

Coverage: Approximately 200-500sq.ft., depending on porosity of stone.

Price: $38.00

    Quantity:

    DIRECTIONS:  Remove all dust and debris using an auto-scrubbing machine or scrub brush on floor machine and portable or truck mounted extractor.  If surface has remaining contaminants use and appropriate surface prep cleaner to remove any remaining surface contaminants which may compromise  uniform wetting, penetration and performance of the densifier.  Allow wet surfaces to dry.

    Fill a low pressure sprayer with product.  Do not dilute with water.

    Apply sufficient product to wet the surface without producing puddles.  Use a clean soft bristle push broom or micro-fiber pad to spread the product evenly and ensure uniform wetting.  Avoid spreading once drying begins.  Scrubbing is not necessary.

    If surfaces dry immediately, increase the rate of application.  Surface should remain wet for 10-15 minutes.  Adjust rate of application to minimize puddles, allowing excess material to puddle on the floor will extend dry times and create white residues which must be removed immediately.  Use push broom to spread as needed.

    Allow treated surfaces to dry as long as possible before next Cheetah Pad step, overnight is an ideal dry time.

    Remove any dried powder residue using a stiff broom, power sweeper or floor scrubbing machine.  

    Using progressively finer Cheetah Pads or Cheetah Pucks, continue polishing in consecutive levels to achieve the desired finish, buff with monkey pad.  Remove all polishing dust and debris using an auto scrubbing machine, truck mounted or portable extractor.  Final polishing is done with Monkey Pad - choose a grit level that gives the desired sheen.  For high gloss use Nano Guard as final sealer.  Be sure to follow Nano Guard instructions carefully.

    Cleanup: Before product dries, clean tools and equipment with fresh water.

    APPEARANCE: Clear Liquid

    SPECIFIC GRAVITY:  1.114

    ODOR:  Characteristic

    pH (Cone):  10-12

    FLASH POINT:  N/A (WATER-BASED LIQUID)

    PACKAGING:  4 X 1 GALLON CASES

    SAFE STORAGE AND HANDLING:  This product is intended for industrial and institutional use.  Although this is a mild chemical agent, it can cause irritation to eyes and skin.  Avoid contact by wearing protective devices such as safety glasses and rubber gloves. if contact to eyes or skin, flush with water or 10-15 minutes.  If irritation persists, seek medical attention.